Electronic Igniters; Burner Efficiency And Flame Characteristics; Cooktop Burners - DCS RGT-305 Use And Care Manual

COOkTOp USE

ElECTRONIC IGNITERS

If a burner does not ignite, listen for the clicking sound. If the igniter is not
clicking, TURN oFF THE BURNER. Check the circuit breaker for a blown fuse or
a tripped circuit breaker. If the igniter still fails to operate, see page 30, "Be-
fore Calling For service". To light the burner manually, see page 26, "Power
Failure".
NOTE:
If you are using propane gas, a slight pop or flash may occur at the burner
ports a few seconds after the burner has been turned "off". This "extinction
pop" is normal for propane gas.

bURNER EffICIENCy AND flAME ChARACTERISTICS

It is necessary to keep the burner ports and the igniters clean
for proper lighting and efficient performance of the cooktop
burners (Fig. 05). The burner flame should burn completely
around the burner with no excessive noise or lifting. The flame
should be blue in color and stable with no yellow tips. An
improper air-gas mixture may cause either a burner flutter or a
yellow tipped flame. during initial use, foreign particles in the
gas line, or dust in the air around the appliance may cause an
orange flame. This will disappear with use.
flAME hEIGhT
The correct height of the flame mainly depends on the size of
the bottom of the cooking utensil, the material of the cooking
utensil, the amount and type of food and the amount of liquid
in the utensil. Following are some basic rules for selecting
flame height.
For safety reasons the flame must never extend beyond the
n
bottom of the cooking utensil. Never allow flames to curl up the side
of the pan (see Fig. 06). This will discolor or damage the utensil.
Utensils which conduct heat slowly (such as glass-ceramic) should
n
be used with medium to low flame. If you are cooking with a large
amount of liquid, a slightly larger flame can be used.
Broiler: The broiler flame should be approximately 1/8" thick and blue
n
(Fig.07) . This is set at the factory for correct performance.

COOkTOp bURNERS

The cooktop burners must be kept clean. Cleaning of the cooktop
burners should include the igniter. The cooktop burners have an
infinite number of heat settings and there are no fixed positions on
the control knobs between HI and lo. To turn the cooktop burner on,
push in on the control knob and turn it counterclockwise to the "lITE" position. An audible clicking sound will
be heard. When the gas has been ignited by the electronic spark igniter, turn the knob to the desired setting.
(The clicking sound should stop as soon as the burner is lit).
WARNING!
When turning on any cooktop burner, be sure to stop at the "LiTE" position before turning the burner to a flame
setting for cooking. if the burner is not lit and it is turned beyond the "LiTE" position, to Hi, MEDiUM, or Lo, there
could be a burst of flame when the burner does light.
10
IGNITER (kEEP ClEAN)
fig. 05
PRoPER FlAME HEIGHT
fig. 06
FlAME sHoUld BE
Flame should be
sCREEN sHoUld
Screen should
APPRoxIMATElY 1/8"
approximately 1/8"
BE GloWING REd
be glowing red
THICk ANd BlUE
thick and blue
fig. 07