Chapter 2 - Start-Up Instructions; General Notes - ABB 500 Operating Instructions Manual

General notes

CAUTION: it is absolutely essential that the applicable accident prevention
How this chapter is structured
For better understanding the individual steps of start-up work are distinguished by
a) frames
without
These steps of start-up work must always be performed
Example:
b) frames
with
These steps of start-up work have to be performed only when the condition stated
(as heading) applies to the selected drive configuration!
completed, the
Example:
Recommended motor voltages and field voltages
Motor voltage U
DCS 501B / DCP 501B:
DCS 502B / DCP 502B:
Field voltage U
SDCS-FEX-1:
If there is a divergence of more than 10 % between the field supply unit's output
voltage and the rated field voltage U
connecting voltage U
resistor R
(Note: also suitable for fine-balancing the maximum motor voltage)
Field voltage U
SDCS-FEX-2 /
DCF 503 / DCF 504:
Field voltage U
DCF 501B / DCF 502B:
Maximally possible output voltage U
DCF 501B / DCF 502B:
DCS 500B / DCP 500B Operating Instructions
regulations be observed by the user (in this context, please also
read the chapter entitled "Safety Instructions")!
any additional marking on the left side:
522 = GERMAN
Activates German texts on the display ...........
marking on the left side
mandatory start-up work
Only when connection diagram 1 (Appendix A) is being used!
906 = 12502
Function „EMERGENCY STOP" de-activated ............
when the following units are used
A
U
U
(= max. output voltage) when the following is being used
F
U
should be reduced, using a matching transformer or a series
N
: R
v
when the following is being used
F
U
when the following is being used
F
U
U
3ADW000055R0401_DCS500B_Operating Instruction_e_d

Chapter 2 - Start-Up Instructions

[Only with the SDCS-CON-2 control board & the CDP 312 panel!]
(„columns" shaded in grey)
has to be continued
= Line voltage * 1.16
Amax
= Line voltage * 1.05
Amax
= Line voltage * 0.9
F
stated on the motor's rating plate, then the
Frated
= (0.9 * U - U ) / I
v N F F
= Line voltage * 0.6 ... 0.8
F
= Line voltage * 0.5 ... 1.1
F
using
Amax
= Line voltage * 1.35
F
(= mandatory start-up work)!
:
After this work has been
.
(2- quadrant unit)
(4- quadrant unit)
I = Rated field current
F
IV A
2 - 1