ABB 500 Operating Instructions Manual page 60

Chapter 4 - Signals and Troubleshooting
Code Text on
seven
LCD of control panel
segm.
CDP 31x
display
F 34 Arm. curent ripple
F 35 Field ex.2 overcurr
F 36 Field ex.2 comerror
Motor overspeed
F 37
F 38 Phase sequence
fault
F 39 No field ack.
IV A
4 - 8
Definition /
Action
Armature current ripple
One or several thyristors carry no current.
Check: - Current feedback with oscilloscope
(6 pulses within one cycle visible?)
- Branch fuses, thyristor gate con
nection; gate-cathode resistance.
- Sensitivity of monitoring function:
set CUR_RIPPLE_LIM [421] (de
pending on methode; see A 137)
FIELD EXCITER 2 (field supply 2)
{See Fault Code
F 32
FIELD EXCITER 2 communication error
{See Fault Code
F 33
Motor overspeed
Speed feedback higher than parameter
.
[P 2204]
Check: - Scaling of speed controller loop;
- Drive speed;
- Field refererence values;
- Speed feedback and connection
of speed feedback;
- Was the motor accelerated by
the load?
Phase sequence fault of power section
Change supply phase sequency or make
correction with parameter
: Direction of rotation of 3-phase
Attention
fan correct?
No field acknowledge from FIELD EXCITER
This message is either caused by the field exciter´s
missing „ready for operation" signal (1) or the field
current being lower than the threshold (2). Reasons
for (1):
- field supply not in synchronism, or
- electronic power supply for the field unit not within
permissible limits
- power supply for the field unit not within permissi-
ble limits
Reasons for (2):
- field supply unit is broken
- field reversal took too long time
- field current lower than threshold because
3ADW000055R0401_DCS500B_Operating Instruction_e_d
overcurrent
}
}
.
[P 506]
DCS 500B / DCP 500B Operating Instructions
Status Remark
signal
(FAULT_WORD_1/2)
11102 bit 0 (3)
modified
in
S21.232
11102 bit 1 (1)
11102 bit 2 (1)
11102 bit 15 (3)
11102 bit 3 (3)
11102 bit 4 (1)