Fault Resetting (Reset); Emergency Stop Resetting (Reset) - ABB 500 Operating Instructions Manual

Chapter 3 - Handling of Control Panel CDP 31x

3.6 FAULT RESETTING (RESET)

3.7 EMERGENCY STOP RESETTING (RESET)

IV A
3 - 8
FAULT resetting and EMERGENCY STOP resetting (RESET) can
only be performed via the CDP 31x if LOCAL is active. If drive is in
REMOTE, please check whether LOCAL is a critical condition. If not
activate LOCAL, reset the fault and activate REMOTE again.
Step Function
1. To enter the Actual Signal
Display Mode
2. To RESET the FAULT
Step Function
1. If EMERGENCY STOP is acti-
vated, the control panel will
show the following ALARM
2. To enter the Fault History Dis-
play
3. To RESET the ALARM
3ADW000055R0401_DCS500B_Operating Instruction_e_d
Press key
ACT
RESET
Press key
RESET
DCS 500B / DCP 500B Operating Instructions
Display after key is
pressed
0 L 0.0 rpm 00
DCS500
*** FAULT ***
I/O-Board not found
0 L 0.0 rpm 00
SPC:OUT 0.0 %
_
CONV CUR 0 A
U ARM AC 0 V
Display after key is
pressed
0 L 0.0 rpm 00
DCS500
** WARNING **
+Emergency stop
0 L 0.0 rpm 00
1 LAST FAULT
+Emergency stop
xxxx:xx:xx.xx
0 L 0.0 rpm 00
1 LAST FAULT
-Emergency stop
xxxx:xx:xx.xx