ABB 500 Operating Instructions Manual page 71

Code
Para- Text on LCD of con-
/
meter trol panel CDP 31x
bit
6 READ APPL BLOCKS
11202 --
7 ERASE ERROR
8 ERASING...
PROGRAM ERROR
9
10 PROGRAMMING...
11 WRONG FLASH TYPE
12 READING...
13 READ ERROR
14 reserved
15 VERSION ERROR
16 reserved
17 SIZE ERROR
11203 --
(FEXC1_RDY_OPER)
00
01 (FEXC1_OK)
02 (EXC2_RDY_OPER)
03 (EXC2_OK)
(ACK_FEXC1_ON)
04
05 (ACK_FEXC2_ON)
06 (FIELD_HEAT_ON)
07 (FIELD1_REV_ACK
(ACK_CSC_ON)
08
09 (ACK_FEXC_ON
10 (FIELD_REF_ON)
(FIELD1_CURR_MIN_L)
11
DCS 500B / DCP 500B Operating Instructions
Load application; if additional function blocks are ac-
tivated and saved via SAVE MOTx SET and modified
afterwards without saving the configuration before
the last modification (the one directly after the last
SAVE action) can be activated
---- While the command is executing the value of
BACKUPSTOREMODE will show what is happening
or the reason for error if the command fails
Error during erasing of parameter flash
Erasing the parameter flash
Error during programing of parameter flash
Programing the parameter flash
Verification error
Reading the parameter flash
Error during reading of parameter flash
Bad type of parameter flash
Bad size of parameter flash
---- FEXC_STATUS:
Status of the field exciters 1 and 2
0 = not ready for operation; AC-voltage missing
0 = self diagnostic failed or power failure in FEX 1
0 = not ready for operation; AC-voltage missing
0 = self diagnostic failed or power failure in FEX 2
1 = motor 1 field OK
1 = motor 2 field OK
1 = motor heating function active
direction of the field 0 = forward, 1 = reverse
1 = on-command accepted by sequence control
1 = motor field OK
1 = field current reference released
1 = motor 1 field current above min level
3ADW000055R0401_DCS500B_Operating Instruction_e_d
Chapter 4 - Signals and Troubleshooting
Definition / explication of the signal Remark
IV A
4 - 19