Table of Contents
Advertisement
Chapter 3 - Handling of Control Panel CDP 31x
3.1 Overview
Panel Link
Mounting the
Panel
DCS 500B / DCP 500B Operating Instructions
The Control and Display Panel [Control Panel] is used for parame-
ter setting, for feedback value measuring and for drive control with
series DCS 500B / DCF 500B and DCP 500B thyristor power con-
verters. This device is available in different versions depending on
the type of unit and software to be used:
Units with software S 21.1xx
Units with software S 21.2xx
Hereinafter CDP 31x will be used as a common type designation for
the above mentioned versions of Control Panel. Differences be-
tween the versions which have to be taken into account with par-
ticular functions will be indicated separately!
The CDP 310/311 Control Panel is connected to the drive via
CDI-300 communication bus.This communication bus, which is
based on the RS485 standard, is a common bus protocol for ABB
Drives products.
MODBUS is used as communication bus connecting the CDP 312
Control Panel to the drive. This Control Panel combined with a
Software version S 21.2xx onwards makes it possible to show the
texts on the LCD in different languages.
The selection of language is performed by parameter
Note:
The display texts as shown in this chapter correspond
to the default setting of
The CDP 31x Control Panel can be handled in three different ways:
Direct mounting on the thyristor power converter; the CDP 31x is
plugged into the moulded part of the cover of the converter and
connected via an adaptor of approx. 45 mm.
Mounting on the door of the switchgear cabinet using an assem-
bly kit equipped with a connection cable.
Use of Panel as remote control device with a connection cable.
3ADW000055R0401_DCS500B_Operating Instruction_e_d
⇒
CDP 310 or CDP 311
(recommended: CDP 311)
⇒
CDP 312
( ⇒ English)!
[P 522]
.
[P 522]
IV A
3 - 1
Hide quick links:
Advertisement
Table of Contents
