Call Channel Operation - Icom IC-3220A Instruction Manual

6 CALL CHANNEL OPERATION
W Calling up a call channel
One call channel is equipped with each band. The
call channels are programmable for storing your
most-often-used frequencies. The call channels are
separate from the memory channels.
Ss ~
Push [BAND] to select VHF or UHF.
X
Push [M/CALL] until "C" appears.
eA call channel is selected.
g
To return to VFO mode, push [V/MHz].
To return to MEMORY mode, push [M/CALL].
E Programming a call
channel
1) Call up the desired band call channel as described
above.
e"C" appears.
2) Push [V/MHz] to select VFO mode.
e"C" changes to small "c".
3) Set the desired frequency (and duplex when
required) to be programmed into the call channel.
4) Push and hold [MW] for 2 sec.
5) After the frequency is written into the call channel
and you want to check the contents, push
[M/CALL] to select the call channel.
W Transferring the contents
of a call channel
The contents of a call channel can be transferred into
a VFO.
1) Call up the desired call channel as described at
left.
2) Push and hold [MW] for 2 sec. :
eThe transceiver goes into VFO mode auto-
matically.
e"C" changes to small "c".