Icom IC-3220A Instruction Manual page 27

SCANNING OPERATION 7
using SET MODE
e SETTING MEMORY
SKIP CHANNEL
usne SET MODE
e SETTING RESUME CONDITION [VIU same setting
Push [M/CALL] until "M" and a memory channel number
appear on the function display to select MEMORY
mode.
1) Push [SET] several times until "SC" appears on the
function display as shown above.
e Refer to p. 13 for SET mode details.
Rotate the main dial to set the desired timer. Select the memory channel to be set as a skip channel.
et-5: Scan resumes 5 sec. after the scan pauses.
*©t-10: Scan resumes 10 sec. after the scan pauses.
et-15: Scan resumes 15 sec. after the scan pauses.
e P-2: Scan pauses until signal disappears and
resumes after 2 sec.
Push [SET] several times until "-CH-" appears on the
function display.
e Refer to p. 13 for SET mode details.
Rotate the main dial to illuminate the "SKIP" indicator.
e "SKIP": The memory channel is skipped during
memory scan.
e" ": The memory channel is scanned during
memory scan.
Push any switch except [SET] and [HI/LO], or push PTT
to set the value and to exit SET mode.
e SETTING PROGRAM SCAN EDGES
Memorize scan edge frequencies in the memory channels
P1 and P2 as in "Programming a memory channel" on p. 21.
Push any switch except [SET] and [HI/LO], or push PTT
to set the condition and to exit SET mode.
e P1 is next to memory channel 18.
e VHF and UHF scan edge frequencies must be separately
programmed.