Icom IC-3220A Instruction Manual page 23

W Transferring memory data
You can transfer the contents of a memory channel
into the VFO.
1) Call up the desired memory channel as desribed on
p. 21.
2) Push and hold [MW] for 2 sec.
¢The contents are transferred to the VFO.
eThe transceiver goes into VFO mode auto-
matically.
Mi Memory split function
This function allows you to operate different frequen-
cies for transmitting and receiving using a pair of
memory channels.
One memory channel is an odd number and the other
is an even number. Memory channels 1 and 2, 3 and
4,5 and 6....... 17 and 18 can be used.
1) Push [BAND] to select VHF or UHF.
2) Set the memory split condition when the trans-
ceiver is not in the condition.
¢See at right.
MEMORY CHANNEL OPERATION 5
3) Push [M/CALL] to select MEMORY mode.
4) Push and hold [DUP] until " G™D " appears.
e The function is activated.
5) Select the memory channel programmed as your
desired receive frequency.
eWhile transmitting, the function display shows
the other side of a pair'of memory channels
eTo program the memory channel, see p. 21 Pro-
gramming a memory channel.
6
To return to normal memory channel operation,
push and hold [DUP] until " G™> " disappears.
—
wrm POWER ON
e SETTING THE MEMORY SPLIT CONDITION
The transceiver must be in the memory split condition when
operating the memory split function. No indications
appear even if the transceiver is in the memory split
condition.
1) Turn power OFF.
2) While pushing and holding [DUP] and [MONI], turn
power ON. Then release these switches.
3) To cancel the condition, reset the CPU. See p. 40 for
details.