Warning System; Warning Description Tables - Panasonic AG-HPX500 Operating Instructions Manual

Warning System

Warning Description Tables

If a problem is detected immediately after the power is turned on, or during operation, this will be indicated by the
WARNING lamp, lamps inside the viewfinder and a warning tone.
LCD or
Warning
Priority viewfinder
type
indication
SYSTEM ERROR
System
1 Cause indication *
error
Red blinking
Incorrect TURN POWER
2 P2 card OFF
removal Blinks red
LOW BATTERY
Red blinking, and
the battery level
bar blinks with
The
the empty status.
3 battery is
(This indication
exhauseted
appears also
when MENU
indications have
been turned OFF.)
FULL
P2
P2 card
Blinks red
4 fully
(appears only for
recorded
3 seconds in MCR
mode.)
REC WARNING
Recording
5 Cause indication *
error
Blinks red
1394 1394INTIAL
6 connection ERROR
errors Blinks red
PC mode
1394
7 HOST
connection
error
142
Warning System
Viewfinder
Tally
LED
lamp
(except tally)
Blinks 4
1 No times per
second
Blinks 4
No times per
second
Blinks 1
No time per
second
Blinks 4
When SAVE
times per
LED is set to
second
P2CARD, the
after
SAVE LED
completion
blinks 4 times
of
per second.
recording.
Blinks 4
No times per
2
second
Blinks 4
times per
No second
during
recording.
Blinks 4
No No times per
second
Warning description
Warning Alarm
and recording/
lamp tone *
6
playback operation
Blinks 4 P2 microprocessor
Continuous
times per or control failure.
tone
second Operation stops.
A P2 card was
removed during
Blinks 4
Continuous access and card data
times per
tone was corrupted.
second
All four access LEDs
blink orange (4 Hz)
The battery is
exhausted.
Recording and
Continuous
Lights playback stop.
tone
The camera stops
automatically when
the voltage drops.
Lights Continuous No more space
after tone after on P2 cards left
completing completing for recording.Stop
recording recording recording. *
Intermittent
Blinks 4 A recording error
tone 4
times per has occurred. Stop
times per
second recording. *
second
Blinks 4
times per Incorrect 1394
second No connection or signal
during input/output error.
recording.
The 1394 cable
has become
Blinks 4 disconnected or
times per No multiple devices are
second connected. (Normal
PC mode operation is
possible.)
Countermeasures
Check the cause
indication * 1 and
consult your
distributor.
Turn off the power.
Repair the P2 card if
the clips on the card
are corrupted.
Replace the battery.
Delete clips that are
no longer needed or
insert a new card.
3
Turn the power off
and then back on
again and check
recording and
playback. Replace
4
any P2 card that does
not enable normal
recording.
Check camera and
external device
connections and
reconnect as
necessary. Then turn
the power off and
back on again.
Connect a hard disk
drive according to
supplied operating
instructions.