Panasonic AG-HPX500 Operating Instructions Manual page 87

• When the power is turned on, a rush current
occurs. If the power supply is insufficient
during this time, the camera may be damaged.
Therefore, we recommend using an external
DC power supply that provides at least twice
the total power consumed by the camera and
all the devices connected to the unit that power
on when the camera powers on (example:
viewfinder). We also recommend using the
proper DC cable recommended for your external
DC power supply.
• When using an external power supply other
than the AC adapter, check the DC IN socket pin
information to ensure correct polarity. If a +12 V
power supply is accidentally connected to the
GND terminal, this could cause a fire or personal
injury.
4
1
2 3
DC IN Socket
<Notes>
• When both the battery pack and the external DC power
supply are connected, power is supplied from the
external DC power supply. The battery can be removed
or mounted while using an external DC power supply.
• When using an external DC power supply, make sure
you turn on the external DC power supply before
turning on the camera-recorder's power switch. If
this sequence is reversed, the camera-recorder may
malfunction due to slow rising of the external DC power
supply voltage.
• To connect a battery to the DC IN connector, select
BATTERY in the EXT DC IN SEL item, and select the
battery type in the BATTERY SELECT item in the
BATTERY SETUP screen. Note that with these settings,
the "%" indication cannot be displayed, even for
batteries capable of indicating remaining power.
• Before connecting an external DC power supply, make
sure its output voltage is compatible with the rated
voltage of the camera.
Pin No. Signal
1
GND
-
2, 3
4 +12V
87
Power Supply