Panasonic AG-HPX500 Operating Instructions Manual page 140

Inspection of the clock, time code, and
user bits
1
Set the user bits as required.
Please refer to [Setting the User Bits] (page
60) for the setting procedures.
2
Set the time code.
Please refer to [Setting the Time Code] (page
62) for the setting procedures.
3
Set the TCG switch to [R-RUN].
• Press the COUNTER button to display the
time code on the LCD monitor or in the
viewfinder.
4
Press the REC START/STOP button.
• Check that the counter display number
changes as recording progresses.
5
Press the REC START/STOP button
again.
• Check that recording stops and the counter
display number stops changing.
6
Set the TCG switch to [F-RUN].
• Check that the counter display number
changes regardless of recording status.
7
Hold down the DISP/MODE CHK button
to check the date and time on the LCD
monitor or in the viewfinder.
• Adjust the date and time setting if the DATE,
TIME and time zone is not correctly displayed.
For details, see [Setting Date and Time of
Internal Clock] (page 28).
<Note>
Note that date and time data set for DATE, TIME,
and time zone is recorded in clips, and affects
the playback sequence, etc. at the time of
thumbnail manipulations.
140
Inspections Before Shooting