Deleting Clips; Restoring Clips - Panasonic AG-HPX500 Operating Instructions Manual

<Note>
When adding a shot mark to (or deleting the shot mark
from) a clip recorded across multiple P2 cards, do this
with all these P2 cards inserted into P2 card slots.

Deleting Clips

1
Press the MODE button to enter the
MCR mode.
• The thumbnail screen appears on the LCD
monitor.
2
Use the cursor buttons to move the
pointer over the clip you want to delete,
and press the SET button.
• Press the SET button to select the clip.
3
Press the thumbnail menu button to
select OPERATION → DELETE from the
menu bar.
4
A screen to confirm the delete
operation appears. Use the cursor
buttons and the SET button to select
YES.
• The clip is deleted.
• All selected clips (in blue-green frames) are
deleted by this operation.
<Note>
After selecting multiple clips and during deletion with
"CANCEL" indication displayed, pressing the SET button
stops the deletion operation in the middle.
108
Clip Operations

Restoring Clips

Restores clips that are defective as a result of sudden
poweringdown during recording, or removal of the P2
card being accessed.
<Note>
• Only those clips with yellow corrupt clip markers can
be restored. Delete the clips with red corrupt clip
markers. If the clip cannot be deleted, format the P2
card.
• During restoration of the clips, however, the defective-
clip indicator may change from yellow to red, resulting
in inability to restore the clips.
1
Press the MODE button to enter the
MCR mode.
• The thumbnail screen appears on the LCD
monitor.
2
Use the cursor buttons to move the
pointer over the clip you want to restore
(defective clips are indicated by corrupt
clip marks), and press the SET button.
• Press the SET button to select the clip.
3
Press the thumbnail menu button to
select OPERATION → REPAIR CLIP
from the menu bar.
<Note>
To restore a bad clip generated during loop
recording, select REPAIR CLIP (LOOP). Clip
repair may take some time.
4
The confirmation window appears. Use
the cursor buttons and the SET button
to select YES.