•
Remote Packages: Enter a valid remote access package for the Normal schedule, and any
other schedules that you want this line to be part of (incoming calls from remote users or
private networks)
4
Assign the lines to DNs (Assigned DNs tab)
If you have configured the DNs and know to which telephones the line needs to be assigned,
you can enter those DNs here. The DN record also can be used to assign lines and line pools
for these lines.
•
Appearance Type: Choose Appr only or Appr&Ring if the telephone has an available
button, otherwise choose Ring only. Model 7000 and 7100 telephones have no
programmable buttons, so this must be set to Ring only. (Model 7000 phones, supported in
Europe only.)
•
VMsg set: When activated, an indicator on the telephone appears when a message from a
remote voice-mail system is waiting. Check with your system administrator for the system
voice mail setup before changing this parameter.
5
Suggested next steps:
•
Dialing plan
"Dialing plan: System settings" on page 267
"Dialing plan: Public network" on page 275
"Dialing plan: Routing and destination codes" on page 259
•
Networking
"Public networking: Setting up basic systems" on page 289
"Public networking: Tandem calls from private node" on page 293
"Private networking: Using destination codes" on page 339
Chapter 15 Configuring lines: T1-Digital Ground Start
Networking Configuration Guide
167