Nortel BCM50 Configuration Manual page 109

Figure 24 Call-by-Call Service Selection subpanel
Table 15 describes the fields shown on the Call-by-Call Service Selection tab panel.
Table 15 Call-by-Call Service selection panel fields
Attribute
Service Type
Translation Mode
Translate All Calls To
Actions
Add
Delete
Value
Foreign Exchange
Inwats (1-800)
Intl-800
Digital (SDS)
900
None
All
By SID
By Number
1. On the Modules table, select the PRI module you want to configure.
2. Select the Service Type record to which you want to add Digit translations
3. Under the Translate table, click Add.
4. Enter the appropriate information in the From and To fields on the dialog box.
5. Click OK on the dialog to save the translation range.
1. On the Modules table, select the PRI module record you want to delete.
2. Select the Service Type record from which you want to delete Digit translations
3. On the Translate table, select one or more ranges to delete.
4. Click Delete.
5. Click OK on the confirmation dialog to delete the digit translation range.
Chapter 9 Configuring telephony resources
Description
Refer to "CbC services available by switch protocol" on
page 110.
Define how the incoming digits get mapped to line numbers
(target lines or DISA/AUTO DNs) within the system.
Enter the appropriate information for the mode chosen.
Networking Configuration Guide
109