Nortel BCM50 Configuration Manual page 119

Table 22 H323 Settings fields (Sheet 2 of 5)
Field
Forward redirected OLI <check box>
Send name display
Remote capability MWI <check box>
Normal route fallback
to
Gateway protocol
Gatekeeper digits
Gatekeeper wildcard
Ignore in-band DTMF
in RTP
Value
<check box>
None
Prime set
None
SL1
CSE
<0-9>
<check box>
<check box>
Chapter 9 Configuring telephony resources
Description
If the check box is selected, the OLI of an internal telephone
is forwarded over the VoIP trunk when a call is transferred to
an external number over the private VoIP network.
If the check box is cleared, only the CLID of the transferred
call is forwarded.
When selected, the telephone name is sent with outgoing
calls to the network.
This setting must coordinate with the functionality of the
remote system hosting the remote voice mail.
Select None or Prime set. If Prime set is selected and the
outgoing IP trunk leg of the call in a tandem scenario cannot
be completed, the call will terminate on the prime set for the
line.
Default: None
Both these protocols require a keycode.
SL1: Use this protocol only for BCM 2.5 systems
CSE: Use this protocol for BCM 3.0 and later systems. This
protocol supports Meridian 1 IPT.
Otherwise, use None.
If dialed digits match gatekeeper digits, the call is routed via
H323 protocol.
If the digits do not match, the call is routed via SIP protocol.
If selected, all dialed digits match gatekeeper digits and
VoIP calls will be routed through the gatekeeper.
If selected, the BCM ignores audible in-band DTMF tones
received over VoIP trunks after the BCM connects the
remote end to a locally hosted call center application, or a
locally hosted CallPilot application such as auto attendant,
voice mail or IVR.
Note: This setting is useful (should be selected) when the
far end is a Call Server 2000 (CS2K) & Packet Voice
Gateway (PVG) combination where the PVG is provisioned
for OOBDTMFSupp=FullSupport resulting in the PVG +
CS2K sending out-of-band, as well as in-band, DTMF tones
at the same time to the BCM. The PVG MAY not send both
tone notifications depending on whether the call is using
G711 and the version of the CS2K software release (i.e.
SNxx).
This setting should be co-coordinated with the CS2K
administrator.
Default: Cleared
Networking Configuration Guide
119