Nortel BCM50 Configuration Manual page 117

Table 21 Routing Table fields (Sheet 2 of 2)
Attribute
GW Type
GW Protocol
VoIP Protocol
QoS Monitor
Tx Threshold
Actions
Add
Delete
Value
BCM
BCM35
IPT
Other
SL1
CSE
None
H323
SIP
<check box>
<0-5>
1. On the Remote Gateways panel, click Add.
2. On the Add dialog:
3. Name: Enter a short descriptive title for the remote system.
4. Destination IP: Enter the public IP address of the remote system.
5. Click OK.
6. On the Remote Gateways panel, click in the fields to set any other parameters that
you require.
1. On the Remote Gateways panel, select the gateway you want to delete.
2. Click Delete.
3. Click OK on the confirmation dialog box.
Chapter 9 Configuring telephony resources
Description
Choose the type of system that is accessed through the
remote gateway:
BCM: BCMs running 3.6 or later software and CallPilot with
compatible versions of H.323.
BCM35: for BCMs running 3.5 software.
IPT: Meridian 1 system running IP software.
Select the gateway protocol that the trunk expects to use.
None: No special features.
SL1: Use for BCM 2.5 systems only that require MCDN over
VoIP trunks.
CSE: MCDN protocol for gateways that provide VoIP
service through Meridian 1 IPT (BCM 3.6 and newer
software) or CSE1000 gateways (BCM 3.0 and newer
software)
Select the routing protocol for your network.
If you intend to use a fallback PSTN line for this gateway,
ensure that this check box is selected.
Ensure that QoS Monitor is also enabled on the remote
system.
Otherwise, leave the check box empty.
Indicate the level of transmission at which the signal must
be maintained. If the signal falls below this level the call falls
back to PSTN.
Default: 0
Networking Configuration Guide
117