GRAPHTEC ASF1-30 User Manual page 14

3.
Use a Phillips screwdriver to attach the Tray fixing bracket (A) and the Tray fixing bracket (B) with the four
Screws B.
After installing the Tray fixing brackets, if you will be using the Paper output tray at a 45-degree angle, go to
step 4. If you will be using it on a tabletop, go to step 5.
Supplement
When attaching the Tray fixing bracket (A) and (B), make sure that the Tray protection tape that stuck on the
Tray fixing bracket (A) and (B) are positioned on the inside before attaching them.
Tray fixing bracket (B)
4.
When fixing the Paper output tray at a 45-degree angle.
Use the two Screws A to fix the Paper output tray while supporting it with your hands.
The output tray can be extended from the table and used as a ramp.
Supplement
•
It is recommended that you use the output tray at a fixed 45-degree angle.
•
The media may protrude from the paper output tray due to its curling or hardness.
If this occurs, set the eject speed of the CE8000-40 to [SLOW].
Screw B
Tray protection
tape
Screw A
ASF1-30 base
CE8000 base
Tray fixing bracket (A)
Screw A
1-6
Screw B