Kyocera KM-C4008 Operation Manual page 176

Section 7 COPIER MANAGEMENT
Response to exceeded restriction
Perform the following procedure to determine whether further use
of the machine will be canceled or an error message will be
generated when a department ID-code has exceeded its set limit.
1
Select "Excess of limit Setting" under the "Setting item"
column on the left side of the touch panel and then press
the "Change #" key.
The "Excess of limit Setting" screen will be displayed.
Inch specifications
Managem. Def. Set.
Setting item
Scanner Managem. On
Fax Management On
Excess of limit Setting Unable to us
Def. Val. of coun. limit 999999
Total size 1 8
Total size 2 11"x17" No specif.
Total size 3 8
Default setting - Management - Managem. Def. set.
Metric specifications
Managem. Def. Set.
Setting item
Scanner Managem. On
Fax Management On
Excess of limit Setting You cannot u
Def. Val. of coun. Limit 999999
Total size 1 A3 No specif.
Total size 2 A4 No specif.
Total size 3 B4 No specif.
Default setting - Management - Managem. Def. set.
7-36
Value
/ x11" No specif.
1
2
hange #
/ x11" No specif.
1
2
Value
hange #
2
To cancel further use of the machine, press the "Is not
permitted" key. To have an error message generated, press
the "Only warning" key.
Inch specifications
Excess of limit Setting
Selection method of limitation.
Default setting - opy default - Managem. Def. set.
lose
Metric specifications
Excess of limit Setting
Selection method of limitation.
Default setting - opy default - Managem. Def. set.
lose
NOTE
If you want to quit the displayed setting without changing
it, press the "Back" key. The touch panel will return to the
screen in step 1.
3
Press the "Close" key.
The touch panel will return to the screen in step 1.
Back
Is not
permitted
Only
warning
Back
Is not
permitted
Only
warning
lose
lose