Kyocera KM-C4008 Operation Manual page 128

Section 6 OTHER CONVENIENT FUNCTIONS
2
Select how you want the copy sets to be finished by pressing
the "Staple Mode" key or the "Punch Mode" key, as
appropriate.
Follow the instructions on the right side of the touch panel
and verify the direction in which the originals were set.
Inch specifications
Ready to Job build.(Full-color)
Place originals then press Start key.
Finished
Offset
Off
On
Metric specifications
eady to Job build.(Full Col.)
Set original. Press Start key.
Finished
Group
none
1 set
IMPORTANT!
If the designation for the direction that the originals are
set is not correct, copying may be accomplished
incorrectly.
3
Press the "Close" key.
The touch panel will return to the screen in step 1.
6-76
Back
Staple Punch
Select Original Image
Direction.
Staple Punch
mode mode
Top Edge
Back
Staple Punch
Check direction
Check direction of
original.
Staple
Punch Mode
Mode
Back Edge
Making copies at an enlarged or reduced
magnification ratio
This procedure selects the magnification ratio of the finished
copies.
1
With the content of the "Basic" tab displayed, press the
"Reduce/Enlarge" key.
set
The "Reduce/Enlarge" screen will be displayed.
Close
Inch specifications
Job Build - Step 1
Left Top
Edge
Select
paper
Finished
set
Close
Metric specifications
Job Build - Step
Left top
corner
Select
paper
Finished
Ready to Job build.(Full-color)
Place originals then press Start key.
11x8 / 1 sided 1 sided copy
1
2
Original 1 sided/
type 2 sided
1 sided copy-Left
Offset Auto % Top Edge
Finished page #: 0
Reduce Orig. set
/Enlarge direction
Basic Quality Edit
Ready to Job build.(Full Col.)
Set original. Press Start key.
-sided -sided Copy
Original -sided/
type 2-sided
Group AMS Back Edge
Finished page #: 0
Reduce/ Orig. set
Enlarge direction
Basic Quality Edit
set
End
Insert
page
set
End
Insert
blank page
-sided Copy-Left