Technical Data Minicoder - Lenord+Bauer MiniCODER GEL 2444M H Series Operating Instructions Manual

9 Technical data and accessories
9.2

Technical data MiniCODER

Electrical data
Supply voltage U
B
(polarity reversal protected, overvoltage
protected)
Current consumption (without load)
Digital interface
Signal identifiers of the interface
Data transmission rate
Power consumption without load
Power-on time
Mechanical data
Housing material
Weight
Maximum permissible rotational speed
Cable data
Cable structure
(number of cores x core cross-section)
Cable diameter
Minimum bending radius
Maximum permissible cable length
Ambient data
Working temperature range
Operating and storage temperature
range
Degree of protection
Dielectric strength
(1)
Depending on the selected optional extras Mechanically permissible speed depending on the design of the
target wheel (see Technical Information ZAx/ZFx (DS51–ZAx/ZFx).
(2)
Connsider voltage drop on the power supply cable; recommended cable length: maximum 2.5 m (no twisted
pair)
94
Technical data MiniCODER
5 V DC ± 5 %
≤ 80 mA
RS-485 with Mitsubishi protocol:
MHSSI (Mitsubishi High Speed Serial In-
terface)
2.5 Mbit (RS-422/RS-485 compliant)
Request (RQ): Data request signal from
the higher level control system
Data (data): Data output from the
MiniCODER as a response to the
data request signal
2.5 Mbit/s
≤ 0.5 W
< 0.5 s
Zinc die casting
30 g
≤ 100,000 min
9 x 0.15 mm
5 mm
25 mm
≤ 30 m
0 °C to +70 °C
-30 °C to +105 °C
IP 68
500 V AC; as per DIN EN 61439-1
-1(1)
2
[25 AWG]
(2)
Lenord+Bauer
GEL 2444M