Dimensions, Thread Sizes And Units; Notation Of Numbers In Dimensional Drawings - Lenord+Bauer MiniCODER GEL 2444M H Series Operating Instructions Manual

Lenord+Bauer
Structure of the warnings is described in the chapter Safety
1)
Designates the type and source of the hazard!
Describes the hazard and indicates the consequences of non-compliance.
● Describes how to avoid the hazard.
1)
One signal word panel for each hazard level
Structure of preceding and the integrated warnings and general structure of
warnings in the product information
Designates the source of the hazard!
● Describes how to avoid the hazard.
1.5.2

Dimensions, thread sizes and units

The product is based on the metric system. All units are stated in SI units or derived
SI units.
Alternative units are indicated in square brackets [ ].
1.5.3

Notation of numbers in dimensional drawings

The decimal separator is designated by a dot ".".
GEL 2444M
Conventions 1 About these operating instructions
57