Time Code Generator Settings - JVC GY-HM750CHU Instructions Manual

Time Code Generator
Settings
Presetting the Time Code
Time code and user's bit data generated from the internal
time code generator are recorded.
This section describes how to set [TC Preset] in the [TC/UB]
menu. (A Page 88)
[TC GENE.] Setting Switch
Memo :
● When the frame rate setting in [Main Menu] B [Record
Set] B [Record Format] B [Frame & Bit Rate] is 50, 25,
24 , settings cannot be made in [Drop]. (A Page 75)
● You can configure the setting without accessing the [TC/UB]
menu screen. (A Page 51)
Required Settings Before Preset
1
Set the [TC GENE.] switch to REC or FREE .
[REC] Preset data in the time code generator operates in
run mode during recording mode. Set this when
recording continuous time code in connecting
frames.
[FREE] Time code starts to operate in run mode from the
preset time in the time code generator.
2
Select the framing mode for the time code generator
(only when the frame rate setting is 60 or 30 ).
Set using [Main Menu] B [TC/UB] B [Drop].
(A Page 88)
[Drop] Sets the run mode of the time code generator to drop
frame mode.
Use this setting when placing emphasis on the
recording time.
[Non Sets the run mode of the time code generator to non-
Drop] drop frame mode.
Use this setting when placing emphasis on the
number of frames.
[USER2] Button
Memo :
Drop frame/non-drop frame mode
● When the frame rate setting in [Main Menu] B [Record
Set] B [Record Format] B [Frame & Bit Rate] is 60 (30),
the actual number of frames per second is approximately
59.94 (29.97). However, the time code processing
standard is 60 (30) frames. To make up for the frame
number discrepancy, the drop frame mode (Drop) drops
the 00 frame and 01 frame every minute except for
minutes that are multiples of 10.
● On the other hand, the non-drop frame mode (Non Drop)
does not drop frames and ignores the discrepancy with
the actual time.