Connecting External Devices; Connecting An External Monitor - JVC GY-HM750CHU Instructions Manual

Connecting External Devices

Connecting an External
Monitor
To output live or playback video images and audio sound to
an external monitor, select the output signals from the
camera recorder, and connect using an appropriate cable
according to the monitor to be used.
Connecting via Composite/Component Output
Either component or composite signals can be output from the
BNC terminals on the terminal area of the camera recorder.
Connect the external monitor to the [Y/VIDEO] output
terminal for composite signals, or to [Y/VIDEO], [PB], and
[PR] video signal output terminals for component signals.
* Select the output signal using [Output Terminal] in the [A/V
Out] menu. (A Page 92)
* To display menu screens or status screens on the external
monitor, set [Analog Out Char.] in the [A/V Out] menu to
On . (A Page 92)
Composite Output
[Y/VIDEO]
VIDEO IN
Settings for Composite Output
1
Down convert the signals.
You can select the method to down convert HD video
images to SD images during composite output.
Set using [Down Convert] in the [A/V Out] menu.
The available modes include Side Cut , Letter Box
(blackened at the top and bottom), and Squeeze (full size,
compressed at the left and right). (A Page 92)
Memo :
● When [System Definition] in the [Record Format] menu is
set to SD (DV) , selection cannot be made. (A Page 75)
2
Add setup signals.
Setup signals can be added to the output video signals
during composite output.
* You can select whether to add setup signals using [Set Up]
in the [A/V Out] menu. (A Page 92)
[AUDIO OUTPUT]
Component Output
[Y/VIDEO], [PB], [PR]
COMPONENT IN
AUDIO IN
Connecting via SDI
Either HD-SDI or SD-SDI signals can be output from the
[HD/SD-SDI] terminal (BNC) on the terminal area of the
camera recorder.
● Digital video signals, together with embedded
(superimposed) audio signals and time code signals, are
output for both the HD-SDI and SD-SDI signals.
● User's bit output from the [HD/SD-SDI] output terminal is
used as a flag to determine valid video signals. Therefore,
accurate values will not be output.
Memo :
● The sampling frequency for embedded (superimposed)
audio signals is 48 kHz. Time code of the built-in time
generator as well as playback time code are also output.
* Select the output signal using [HD/SD-SDI Out] in the [A/V
Out] menu. (A Page 92)
* When [System Definition] in the [Record Format] menu is
set to SD (DV) , only SD-SDI signals are output.
(A Page 75)
* To display menu screens or status screens on the external
monitor, set [SDI Out Char.] in the [A/V Out] menu to On .
(A Page 92)
Settings for SDI Output
1
Down convert the signals.
You can select the method to down convert HD video
images to SD images during SD-SDI output.
Set using [Down Convert] in the [A/V Out] menu.
The available modes include Side Cut , Letter Box
(blackened at the top and bottom), and Squeeze (full size,
compressed at the left and right). (A Page 92)
Memo :
● When [System Definition] in the [Record Format] menu is
set to SD (DV) , selection cannot be made. (A Page 75)
[HD/SD-SDI]
SDI IN