Side Terminal - JVC GY-HM750CHU Instructions Manual

Introduction
Names of Parts (continued)

Side Terminal

A
B
C
D
E
F
A
[HD/SD-SDI] HD/SD-SDI Output Terminal (BNC)
(A Page 120)
B
[Y/VIDEO] Y/Composite Video Signal Output
Terminal (BNC) (A Page 120)
C
[PB] PB Video Signal Output Terminal (BNC)
(A Page 120)
D
[PR] PR Video Signal Output Terminal (BNC)
(A Page 120)
E
[REMOTE] Remote Terminal (A Page 125)
F
[DC INPUT] DC Input Terminal (A Page 22)
Input terminal for DC 12 V power supply. Connects with an
AC adapter.
G
[AUDIO OUTPUT CH-1/CH-2] Audio Output Terminal
(RCA)
Output terminal for audio signals.
● Input audio signals are output during Camera mode.
● Playback audio signals are output during Media mode.
● Audio from input audio signals is output during HD/DV
signal (IEEE1394) input.
Memo :
● Alarm tone is not output.
I J
G
H
H
[INT/EXT] IEEE1394 Interface Terminal Switch
(A Page 122)
For selecting a valid IEEE1394 interface terminal.
[EXT] Enables IEEE1394 signals from the [IEEE1394]
terminal L.
Enables the accessory connector B at the rear
[INT]
of the camera recorder. (A Page 15)
I
Shoulder Pad Slide Button
For adjusting the shoulder pad position. Press this button to
adjust the shoulder pad J position to the front or back.
J
Shoulder Pad
K
[USB] USB Terminal (A Page 124)
L
L
[IEEE1394] IEEE1394 Terminal (4-pin)
K
For connecting digital video equipment with IEEE1394
terminal using an IEEE1394 cable (sold separately).
To enable this terminal, set the [INT/EXT] IEEE1394 terminal
switch H to [EXT].
( A Page 122 [IEEE1394 Connection])
Note :
● When connecting IEEE1394 cables, check that the
connectors are facing the right direction before you insert.
Memo :
● Put on the covers when the connectors are not in use.