External Device - JVC GY-HM750CHU Instructions Manual

5
Set the external device to a mode that enables
recording.
For setting and operation of external devices, refer to the
instruction manual of the respective devices.
Note :
● Adjust the camera recorder and external device to the
same IEEE1394 settings.
● Start recording only after ensuring that the devices are
properly connected.
6
Perform recording using the camera recorder.
3
If the settings in are appropriate, video images will be
recorded to the camera recorder and external device.
Note :
● Images, audio and time code at the points where
recording starts and ends may be out of sync depending
on the camera recorder and backup device in use.
Memo :
● When backup recording starts, a TRIGGER TO EXT
message appears on the LCD monitor and viewfinder for
about 3 seconds.
Checking Videos Recorded on the

External Device

(IEEE1394 Input mode of Media mode)
When images are displayed in thumbnails in Media mode
(SD Card mode) and power of the device connected to the
[IEEE1394] terminal is turned on, pressing the [CAM/MEDIA]
selection button displays the playback images of the
connected device on the LCD monitor and viewfinder. (Only
for HD video systems)
Pressing the same button has no effect if the [IEEE1394]
connection is not recognized, such as when the power of the
device connected to the [IEEE1394] terminal is turned off.
When an SD video system is in use, availability of the
[IEEE1394] terminal connection cannot be detected in Media
mode (SD Card mode). Allow the camera recorder to detect
the [IEEE1394] terminal connection in advance by turning on
the power of the connected equipment in Camera mode.
Refer to [Status Screen in IEEE1394 Input Mode] (A Page
107) for the status display of this mode.
1
Set the [Record Format] menu according to the input
video format. (A Page 75)
2
Press the [CAM/MEDIA] button to set to the IEEE1394
Input mode.
3
Set the external device to the playback mode.
Video images recorded on the external device are displayed
on the LCD monitor and viewfinder.
Note :
● This mode is used for viewing images input to the
[IEEE1394] terminal from an external device, and not
intended for recording input images on the camera
recorder.