Power Status Display - JVC GY-HM750CHU Instructions Manual

Preparations
Using a Battery Pack
(continued)

Power Status Display

Viewfinder and LCD Monitor Screens
The power status is displayed on the status and menu
screens. If the battery or supplied voltage from the AC
adapter is low, a warning will be displayed in red.
Note :
● If the battery in use is not a recommended one, the battery
mark which indicates the battery level may not appear.
Status Screen
( A Page 100 [Status Screen in Camera Mode])
( A Page 106 [Status Screen in SD Card Mode])
( A Page 107 [Status Screen in IEEE1394 Input Mode])
1280x720 30/24 fps
24p HQ
A
100min
B 100min
F5.6 AE+1 9dB 1/10000
STBY
RES
Enlarged status display on the LCD monitor
(A Page 108)
CH1
CH2
DF
FREE
1280 x 720
STBY
A
min
24p HQ
B 100 min
Menu screen (A Page 70)
0 0 : 0 0 : 0 0 : 0 0
MAX 123%
MIN 45%
S.DTL
B -3
ND1/16 A<3200K>
RES
Warnings by Lamps and Alarm Tones
● Warning status is indicated by tally lamps and alarm tones.
● The front and back tally lamps of the camera recorder
blink.
● Alarm tone is output from the monitor speaker or
[PHONES] terminal.
Memo :
● If you continue to use the camera recorder while the
power warning is displayed, the camera recorder will stop
automatically when the battery or supplied voltage from
the AC adapter becomes lower.
● Alarm tone is not output during recording.
Note :
● The remaining battery power and time are displayed as
there are from the battery information. Accurate data may
not be displayed according to the battery condition.
Replace the battery as soon as possible when the
remaining battery power and time are low.
Precautions for Batteries
● Store the battery in a cool and dry place when not in use.
Do not expose the battery to high temperatures (such as
in a car under direct sunlight). This will cause battery
leakage and shorten the battery life.
● Operating time is shortened if the battery terminal is dirty.
● If the operating time shortens drastically even after
charging, the battery may be reaching the end of its life.
Replace the battery with a new one.
Charging
● Use up the charge completely before you charge the
battery. If the battery is not fully discharged before
charging, the battery capacity may drop after repeated
cycles.
● If the battery capacity drops due to repetitive shallow
charging and discharging, it may be recovered by using
up the charge completely and then fully charging the
battery again.
● If you charge the battery immediately after using while the
battery is still warm, it may not be fully charged.
● It is recommended that you charge the battery in an
environment between 10 f and 35 f. The battery may
not be fully charged or the charging time may be prolonged
if charged under low temperatures (below 10 f).