Remove The Ruggedized Case End-Caps - Oracle Roving Edge Device Setup Manual

Setting Up Oracle Roving Edge Device
No. Description
6
Power switch and LED
• On – Host is powered on
• Off – Host is powered off
• Amber – Fault
7 DB-9 serial console port
* To meet MIL-STD-461 Rev G RE102 requirements, all Ethernet network cables attached to the Roving Edge
Device must be CAT8 rated.
What's next?
• If your device is inside a ruggedized case, see
• If the device isn't in a ruggedized case, install your device in a rack. See
8.

Remove the Ruggedized Case End-Caps

If the Roving Edge Device is in a ruggedized case, you must remove the front and rear end-caps to access the cable
connectors. The end-caps remain removed during operation.
Caution:
Don't remove the Roving Edge Device from the case. Doing so can damage
the device.
Caution:
Leave the end-caps removed during operation to ensure adequate airflow.
Reinstall the end-caps only when the device is powered down.
1. On the front and rear of the ruggedized case, find the 16 wing-turn latches.
Note: The rear end-cap has casters.
Oracle Cloud Infrastructure Roving Edge Device Setup Guide
Remove the Ruggedized Case End-Caps
Mount the Device in a Rack
on page 6.
on page
6