Oracle Roving Edge Device Setup Manual page 10

Setting Up Oracle Roving Edge Device
a. Snap the front slide-rails into the front rack posts.
b. Adjust the rear slide-rails to reach the rear rack posts, then snap the slide-rails into the rear rack posts.
6. Install the device into the slide-rails.
a. Extend the inner-front slide-rails.
b. Slide the mounting brackets into the extended slide-rails until the device is securely supported by the slide-
rails, but is extended from the rack.
c. Pull the green lever forward to enable the mounting brackets to slide fully into the slide-rails.
d. Lift the slide-rail stop lever and push the device completely into the rack.
7. Install two M4 screws to the front of the device.
Oracle Cloud Infrastructure Roving Edge Device Setup Guide 10