Mounting - Bosch rexroth IndraControl SafeLogic compact Operating Instructions Manual

IndraControl SafeLogic compact Sercos
Gateway

10.2 Mounting

WARNING
Disconnect the complete station and the components from voltage before
mounting the components! Connect the voltage only again after the entire sta-
tion has been set up. While operating voltage is applied, modules must not be
plugged to nor be removed from the SafeLogic compact system.
The SafeLogic compact system must be mounted in a control cabi-
net with at least IP 54 enclosure rating.
The SafeLogic compact Sercos Gateway has to be directly connected to the right
of the main module SLC-3-CPU0 or SLC-3-CPU1. The SafeLogic compact Sercos
Gateway is located in a 22.5 mm wide modular system for 35 mm DIN rails ac-
cording to EN 60715. The modules are connected to each other via a plug con-
nection integrated in the housing. Mount the modules in accordance with EN
50274. Ensure suitable ESD protective measures while mounting. Otherwise, the
SafeLogic compact components can be damaged. Take suitable measures to en-
sure that foreign matter does not enter the connector openings, in particular the
openings of the system plug.
Snap the SafeLogic compact Sercos Gateway onto the DIN rail:
1. Hang the device onto the DIN rail ①.
2. Ensure that the earthing spring contact is positioned correctly ②. The
earthing spring contact of the SafeLogic compact Sercos Gateway must
contact the DIN rail securely to allow electrical conductivity.
3. Latch the SafeLogic compact Sercos Gateway onto the DIN rail by pressing
it lightly in the direction of the arrow ③.
Fig. 10-2: Snap the SafeLogic compact Sercos Gateway onto the DIN rail
Mounting, dismounting and electric installation
Do not mount the control, modules or plugs un-
der voltage. The system might start accidental-
ly!
R911338431_Edition 04 Bosch Rexroth AG
15/27