Test Tab - HP Z1 Maintenance And Service Manual

Miscellaneous — List any devices or data that doesn't belong to any other Category.
●
Processors - Shows system processors.
●
Storage — Shows mass storage devices such as floppy drives, optical drives, SATA, SAS hard
●
disk drives and controllers, as well as any RAID arrays.
System — Shows information about system board devices such as fans and cables.
●

Test tab

The Test tab lists all available diagnostics. The lists have been tailored according to your system
configuration. Individual test may be selected or unselected. The following Test Modes exist:
Quick — This test selection was picked to perform quickly while covering your entire hardware.
●
Test parameters cannot be modified.
Complete — This test selection offers all available tests and may take a long time to complete.
●
Test parameters cannot be modified.
Custom — Like Complete this test selection offers all available tests. The test parameters may
●
be modified to fit specific needs. For advanced users only!
By default, the three test modes do not display prompts and require no interaction. If errors are found,
they are displayed when testing is complete.
However, for each test type, you may also optionally add interactive tests by clicking the Include
interactive tests box under Test mode. Selecting interactive tests provides the maximum control over
the testing process. The diagnostic software will prompt you for input during tests.
NOTE: Memory can not be tested from within the HP Vision Diagnostics application. To test the
memory in your computer, exit HP Vision Diagnostic, boot to either the CD or USB flash drive and
select HP Memory Test from the boot menu.
The Duration of Test options control the duration of the test sequence. The following options are
available:
Number of loops — A test selection will run once by default. Enter a positive number to make a
●
test selection run many times.
Total test time (hours:minutes) — Alternatively, the test selection can be set to run for a
●
specified amount of time. This does not guarantee that all tests will run if the entered time is less
than the necessary time to run all the tests
Stop at first error— Check this option to stop test execution as soon as one error is encountered.
●
The following Test Controls exist:
Select All, Unselect All button — This button toggles to select or unselect all the tests from the
●
test selection tree.
Expand, Collapse button — This button toggles to expand or collapse the test selection tree.
●
Start Test button — Click this button to start executing all selected tests. HP Vision Diagnostics
●
will automatically switch to the Status tab in order to keep track of the test execution and status.
WARNING!
completed.
To begin testing:
Once started, do not reboot or power off your computer until all the tests have been
Self-troubleshooting with HP Vision Diagnostics 77