HP Vectra VT6 User Manual page 96

4 Troubleshooting Your PC and Using the Setup Program
If Your PC Does Not Start
If an Error is detected by the Power-On-Self-Test
If an error is detected when the PC starts, the Error Message Utility
(EMU) is launched.
Follow the instructions provided by the EMU.
•
If prompted by the EMU, press
•
error (refer to page 99 for information on using Setup).
Press to continue and ignore the error. (It is recommended that
•
you fix the error before proceeding, even if the PC appears to start
successfully.)
Corrective actions for errors that may prevent your PC from starting
are described in the following table.
Power-On-Self-Test Errors that May Prevent Your PC From Starting:
What you should do:
0130, 0241
0280
1 Ensure the configuration stored in CMOS memory has not been cleared
2 Run Setup to correct the configuration information.
3 If all the above fail to correct the problem, the system board may need
What you should do:
0250
1 Run Setup and correct the errors highlighted by the Setup program.
2 Ensure the configuration stored in CMOS memory has not been cleared
3 If the hardware was changed, run Setup to update the configuration
What you should do:
06xx
1 Ensure that nothing is pushing down on the keyboard, and that no key is
2 If the problem persists, contact your service representative.
84 English
to run Setup and correct the
by the system board switch (refer to chapter 5).
to be replaced. Contact your service representative.
by the system board switch. Make a written note of the configuration.
information.
stuck down.