HP Vectra VT6 User Manual page 25

Installing the HP IDE
Driver
5 Insert "Setup Disk #3" when prompted by the installation program.
6 When
IDE CD-ROM (ATAPI1.2)/Dual Channel PCI IDE
proposed as a mass storage device, press
7 Press to install the drivers for this device from the CD-
ROM.
8 Follow the instructions displayed by the Windows NT installation
program to continue the installation of Windows NT.
9 When the installation program tries to detect the network adapter,
click , then select
Continue
10 Select
No Network
confirm your choice.
11 Continue the Windows NT installation until a dialog box proposes
the type of display connected to your computer.
12 Click to select the
OK
configuration.
13 When the installation of Windows NT is complete, click
to restart your computer.
Computer
To ensure a stable system, you should now install the HP IDE driver:
1 Click the
Windows NT Setup
2 In the menu, choose
Options
3 Select the installed
click on , then
Remove
4 Click , to add a new adapter.
Add
5 Insert the "XU/VT Drivers and Documentation" CD-ROM in the CD-
ROM drive.
6 Choose from the list box, then specify the location of the driver
Other
.
D:\IDE\NT35
7 When the driver named
and then click on
in the next dialog box.
Continue
in the
Add Network Adapter
VGA Compatible Display
icon.
Add/Remove SCSI Adapters
IDE CD-ROM (ATAPI 1.2)/Dual Channel PCI IDE
, to remove the driver.
OK
CMD 64xx 32-bit IDE Adapter
.
Install
1 Setting Up Your PC
Installing an Operating System
is recognized and
to continue.
dialog box, then click
, then click to save the
OK
Restart
.
driver and
is displayed, click
to
OK
OK
English 13