Mounting The Terminal - HP Compaq t1000 Series Supplementary Manual

6
Terminal Installation
Proceed as follows to connect the terminal. (If necessary, remove the desktop
mounting stand (one Phillips-head screw on the bottom.)
Note
Before connecting the cables, decide which mounting
configuration will be used and ensure that the cables
are of the correct lengths. If permanent desktop
configuration is to be used, drill the desktop mounting
holes before connecting the cables.
1. Connect the monitor to the Video connector.
2. Connect the keyboard to the Keyboard connector.
3. Connect the mouse to the Mouse connector.
4. If you will be using a network connection, connect a 10Base-T or 100Base-T
network cable to the Network connector. Be sure to install the supplied noise
suppressor on the cable.
5. Depending on your configuration needs, connect a printer to the parallel port,
and/or connect a modem/server serial cable to the serial ports, as appropriate.
6. Connect the power supply output cable to the Power connector.
Caution
Do not force a connector into its socket. If any undue
resistance is encountered, ensure that the connector is
oriented correctly to the socket.
7. Plug the AC cord into the power supply, then into an AC outlet.
8. After the cables are connected, install the terminal in its planned location (see
the next section "Mounting the Terminal").