Tcp/Ip Telnet Configuration - HP Compaq t1000 Series Supplementary Manual

118
Connection Configuration
The following table discusses the functions of a Telnet connection.
Table 17-1 TCP/IP Telnet Configuration
Function
Host Port Number
Local Port Number
Telnet Name
Suppress
Force Negotiation
Break Settings
Description
Enter the Telnet host port number. The default is 23.
Implemented to allow connection to Misys hosts. This
allows the host to communicate back to the emulator
on a different port than the emulator uses to talk to the
host. The default is 0.
Enter the Telnet virtual terminal name. The default
depends on emulation (VT400, 7-bit, default is vt420).
Use the functions of this group box as needed (controls
in this area become active depending on the type of
emulation selected):
• Echo (default)
• 3270 Regime
• TN3270E
• TN5250E
Use the Binary and EOR drop-down scroll lists to
configure negotiation parameters. The default for
Binary is No and the default for EOR is No.
Use the TM with Break and CR with Break check
boxes to configure break settings.