Firmware Upgrades
Manual Download
Use the following instructions to perform a manual download.
1. Type xfer <filename.ext> at the DOS prompt
2. Press Enter, and the Download Utility dialog box appears. See the following
figure.
Figure 34-1 Download Utility Dialog Box
3. Power-up the terminal to initiate the download.
The Firmware Upgrade dialog box appears, showing that the download is in
progress. When the download is complete, disconnect the parallel cable. The
Setup Wizard will appear.
Note
If the download dialog box remains on the screen
longer than 1 minute, press the Enter key. A prompt to
repeat or quit the operation appears. If the download
fails, quit the procedure, check all cables and
connections, then repeat from Step 2.
203