Ricoh DSc332 Operating Instructions Manual page 1042

Appendix
Parameter
rate [auto|11m
|5.5m|2m|1m]
Note
❒ When changing the interface to
IEEE 802.11b, see p.98 "TCP/IP
address".
❒ When
802.11b TCP/IP, see p.98 "TCP/IP
address".
Job Spool
9
Use the "spoolsw" command to con-
figure Job Spool settings.
Limitation
❒ You can only specify LPR, IPP, and
SMB protocol.
Note
❒ This information cannot reload au-
tomatically when you confirm Job
S p o o l s e t t i n g s w i t h t h e W e b
browser. Click [Reload] or [Refresh]
on the Web browser when you
want to reload this information.
108
Value to be con-
figured
You can set the
IEEE 802.11b trans-
mission speed.
The transmission
speed you specify
here is the speed at
which data is sent.
You can receive
data at any speed.
auto: automatical-
ly set (default)
11m: 11 Mbps
fixed
5.5m: 5.5 Mbps
fixed
2m: 2 Mbps fixed
1m: 1 Mbps fixed
configuring the
❖ ❖ ❖ ❖ Reference
The Job Spool setting appears.
msh> spoolsw
❖ ❖ ❖ ❖ Job Spool setting
msh> spoolsw spool {on | off}
Note
❒ Select [on] to enable Job Spool or
[off] to disable it.
❖ ❖ ❖ ❖ Protocol configuration
To change protocol settings, use
the following command. You can
specify the setting for "lpr", "ipp"
or "smb".
• lpr
msh> spoolsw lpr {on | off}
• ipp
msh> spoolsw ipp {on | off}
• smb
msh> spoolsw smb {on | off}
IEEE
Changing the host name
Use the "hostname" command to
change the printer name.
msh> hostname interface_name
printer_name
Interface name
ether
*2
wlan
*3
ip1394
*1
If you did not enter the interface
name, it will be automatically set to
the Ethernet interface.
*2
Available when the optional IEEE
802.11b interface unit is installed.
*3
Available when the optional IEEE
1394 interface board is installed.
Interface to be config-
ured
*1
Ethernet interface
IEEE 802.11b interface
IEEE 1394 interface