Assigning The Ip Address - Ricoh DSc332 Operating Instructions Manual

Assigning the IP Address

Preparation
Configure the machine to use TCP/IP.
• Make sure that TCP/IP on the machine is set to active. (The default is ac-
tive.)
• Assign an IP address to the machine and configure the other settings re-
quired for TCP/IP.
Reference
For more information about how to make the above settings, see Network
Guide.
Checking the IP address configuration
Follow the procedure below to make sure that the IP address is configured cor-
rectly.
• The following procedure uses the sample IP address: 192.168.15.16.
A A A A
Enter the following:
# ping 192.168.15.16
If the address is configured correctly, the following message appears:
192.168.15.16 is alive
If the address is configured incorrectly, the following message appears:
no answer from 192.168.15.16
Note
❒ When you use NIS, the IP address and host name are written to /etc/hosts
on the master server. When you use DNS, the information is written to a
data file on the name server. After writing the host name and IP address to
the file, make sure that the configuration is correct by pinging the host.
# ping host_name
❒ If the host name is registered with an IP address, the server can access the
printer using its host name instead of its IP address.
Using the Installation Shell Script
1
5