Ricoh DSc332 Operating Instructions Manual page 1034

Appendix
DHCP
Use the "dhcp" command to config-
ure the DHCP settings.
❖ ❖ ❖ ❖ Reference
The following command displays
the current DHCP settings.
msh> dhcp
❖ ❖ ❖ ❖ Configuration
You can configure the DHCP set-
tings.
msh> dhcp interface_name
[on|off]
Note
❒ Select [on] to enable DHCP. Se-
lect [off] to disable DHCP.
❖ ❖ ❖ ❖ Interface Priority Configuration
You can assign priorities govern-
ing which interface obtains DHCP
parameters.
msh> dchp priority
interface_name
Note
❒ Priority assignment is useful when
connecting more than one inter-
9
face to the machine.
❒ If an interface is not selected, it ap-
pears according to the currently set
priority regardless of multiple in-
terface connections.
Interface name
ether
*1
wlan
*2
ip1394
*1
Available when the optional IEEE
802.11b interface unit is installed.
*2
Available when the optional IEEE
1394 interface board is installed.
Reference
For more information about DH-
CP, see p.114 "Using DHCP".
100
Interface to be configured
Ethernet interface
IEEE 802.11b interface
IEEE 1394 interface
Protocol
Use the "set" command to
allow or prevent remote access for
each protocol.
msh> set protocol {up | down}
Protocol
tcpip "up" means active and
"down" means inactive.
appletalk
netware
smb
*1
scsiprint
*1
ip1394
lpr
ftp
rsh
diprint
web
snmp
ipp
http
*1
Available when the optional IEEE
1394 interface board is installed.
Note
❒ If you prohibit remote access via
TCP/IP and then log out, you can-
not use remote access. If you did
this by mistake, you can use the
control panel to allow access by
TCP/IP.
❒ When you prevent access via
TCP/IP, you are also prevented
from using ip1394, lpr, ftp, rsh,
diprint, web, snmp, ipp, and http.
❖ ❖ ❖ ❖ Display
The following command displays
current tcpip, appletalk, netware,
and smb settings.
msh> set protocol