Enable Dynamic Routing - TRENDnet TEW-823DRU User Manual

TRENDnet User's Guide
4
Click Add to add the static route. The static route information appears on the Static
Route List section.
ÍNote: To discard the changes, click Cancel.
Delete a Route
To delete a route, check the box in the No. column to select which routes to delete, then
click Delete.

Enable Dynamic Routing

Advanced > Setup > Routing
You may want set up your router to route computers or devices on your network to other
local networks through other routers. Generally, different networks can be determined by
the IP addressing assigned to those networks. Generally speaking and for the case of an
example, your network may have 192.168.10.x IP addressing and another network may
have 192.168.20.x IP addressing and because the IP addressing of these two networks are
different, they are separate networks. In order to communicate between the two separate
networks, static routing needs to be configured. If you have other routing devices that
support dynamic routing protocol, you can enable these routing protocols on your router
to learn and automatically generate the routes needed between these networks.
ÍNote: Configuring this feature assumes that you have some general networking
knowledge.
© Copyright 2014 TRENDnet. All Rights Reserved.
1
Log into your router management page (refer to
2
Click on Advanced > Setup > Routing.
3
In RIP section, do the following:
ͫ Enable RIP: Click the drop-down list to enable or disable RIP dynamic routing protocol.
ͫ RIP mode: Depending on which RIP version dynamic routing protocols your other
routing devices support, click the appropriate version v1 or v2.
If selecting RIP v2, this requires basic password authentication between
ÍNote:
routing devices using this protocol. The password must match on all routing
devices connected in order successfully exchange routing information.
4
Click Apply to save the changes.
ÍNote: To discard the changes, click Cancel.

The current routing table is visible in Routing Table section.
TEW-823DRU
"Log in to Management Page" on page 8).
28