Operation; Control Panel - HOMCOM 821-042V70 Instruction Manual

● Keep doors and windows closed for energy efficiency.
● Avoid exposing the appliance to direct sunlight or rain.
● During hot days, it is normal for the air outlet to feel warm to the touch during continuous

operation.

● Empty the water tank before moving the device.
● Ensure the water tank is correctly filled; otherwise, the appliance will not operate properly.
● The dehumidifier will start up in the last mode selected during previous use.
● If the room humidity is 3% higher than the selected humidity, the appliance will start
dehumidifying.
● The compressor has a protective three-minute time delay. Wait for three minutes for the
dehumidifier to resume dehumidification.
5. OPERATION

5.1 CONTROL PANEL

Power
Turn on the machine by pressing the power button – the running indicator will light up
and the fan will run at the default high speed, with the default humidity setting of 50%.
When the appliance is operating, press the power button to turn it off – the indicator light
will turn off and the compressor will stop immediately. The fan will shut down after a 30-
second delay.
Mode button
To switch between Auto mode and Continuous mode, press the mode button. Each time
you press it, the mode will switch from one to the other – the corresponding indicator will
light up.
● Auto mode: When the humidity in the environment is 3% higher than the set humidity,
the fan starts working. After three seconds, the compressor starts working. When the
humidity in the environment is 3% lower than the set humidity, the compressor stops
working. After a 30-second delay, the fan also stops working. You can adjust both the
fan speed and the humidity setting in Auto mode.
● Continuously dehumidify mode: In this mode, the machine continuously runs at a
high fan speed. You can adjust the fan speed, but you cannot adjust the humidity
setting.
7