HOMCOM 821-042V70 Instruction Manual page 8

● Sleep mode: In this mode, the target humidity is set to 60%. If there is no operation for
10 seconds, except for the sleeping mode indicator light, all other lights and the
display screen will turn off.
When room humidity is 57% or lower, the compressor and fan will stop working.
When the humidity in the room is 63% or higher, the fan and compressor will start
working.
In sleep mode, if the water tank becomes full, the machine will not produce an alarm
sound. However, the water tank full indicator light will turn on (red colour) to remind you
that the water tank needs to be emptied.
Timer button
- Press the timer button to set, check or cancel the timer.
- In the non-timing state: Press the timer button to enter the timer setting state. The
digital screen will flash, displaying the timer. During the flashing period, use the
adjustment button to set the desired time (from 0-24 hours).
- In the timing state: Press the timer button and the digital screen will flash, showing the
remaining time. Press the timer button again during the flashing period to cancel the
setting.
Fan Speed button
Press this button to switch between high and low fan speed. The corresponding
indicator light will turn on. Fan speed adjustment is only available in Auto mode.
Set button
- Press this button to set the humidity and timer.
- For humidity adjustment: Press once to increase the humidity setting by 5%. The humidity
adjustment follows the order: 30% - 35% - 40% - 45% - 50% - 55% - 60% - 65% - 70% -
75% - 80% - 30% (cycle).
- For timer adjustment: Press once to add one hour to the timer value. The timer follows the
order: 00 – 01 – 02 – 03 – 04 – 05 – 06 – 07 – 08 – 09 – 10 – 11 – 12 – 13 – 14 – 15 – 16 –
17 – 18 – 19 – 20 – 21 – 22 – 23 – 24 - 00 (cycle).
Lock
- Press and hold this button for three seconds to activate the lock function. The indicator
light will turn on – you will not be able to operate other buttons except for this one. Press
and hold the button for three seconds again to deactivate the lock function. The indicator
light will turn off.
8