Changing The Pruning-Eligible List; Configuring The Native Vlan For Untagged Traffic - Cisco WS-C3020 Software Configuration Manual

Chapter 11 Configuring VLANs
To return to the default allowed VLAN list of all VLANs, use the no switchport trunk allowed vlan
interface configuration command.
This example shows how to remove VLAN 2 from the allowed VLAN list on a port:
Switch(config)# interface gigabitethernett0/1
Switch(config-if)# switchport trunk allowed vlan remove 2
Switch(config-if)# end

Changing the Pruning-Eligible List

The pruning-eligible list applies only to trunk ports. Each trunk port has its own eligibility list. VTP
pruning must be enabled for this procedure to take effect. The
page 12-14
Beginning in privileged EXEC mode, follow these steps to remove VLANs from the pruning-eligible list
on a trunk port:
Command
Step 1 configure terminal
Step 2
interface interface-id
Step 3 switchport trunk pruning vlan {add |
except | none | remove} vlan-list
[,vlan[,vlan[,,,]]
Step 4 end
Step 5 show interfaces interface-id switchport Verify your entries in the Pruning VLANs Enabled field of the display.
Step 6
copy running-config startup-config
To return to the default pruning-eligible list of all VLANs, use the no switchport trunk pruning vlan
interface configuration command.

Configuring the Native VLAN for Untagged Traffic

A trunk port configured with IEEE 802.1Q tagging can receive both tagged and untagged traffic. By
default, the switch forwards untagged traffic in the native VLAN configured for the port. The native
VLAN is VLAN 1 by default.
The native VLAN can be assigned any VLAN ID.
Note
OL-8915-03
describes how to enable VTP pruning.
Purpose
Enter global configuration mode.
Select the trunk port for which VLANs should be pruned, and enter
interface configuration mode.
Configure the list of VLANs allowed to be pruned from the trunk. (See
the "VTP Pruning" section on page
For explanations about using the add, except, none, and remove
keywords, see the command reference for this release.
Separate nonconsecutive VLAN IDs with a comma and no spaces; use a
hyphen to designate a range of IDs. Valid IDs are 2 to 1001.
Extended-range VLANs (VLAN IDs 1006 to 4094) cannot be pruned.
VLANs that are pruning-ineligible receive flooded traffic.
The default list of VLANs allowed to be pruned contains VLANs 2 to
1001.
Return to privileged EXEC mode.
(Optional) Save your entries in the configuration file.
Cisco Catalyst Blade Switch 3020 for HP Software Configuration Guide
Configuring VLAN Trunks
"Enabling VTP Pruning" section on
12-4).
11-23