Ipv6 Applications - Cisco WS-C3020 Software Configuration Manual

Chapter 35 Configuring IPv6 Host Functions
This is a site-local address configuration:
switch# show running-config interface fastethernet1/0/16
Building configuration...
Current configuration : 91 bytes
!
interface FastEthernet1/0/16
no switchport
no ip address
ipv6 address autoconfig
end
This is the configuration on the router side:
switch# show running-config interface gigabitethernet1/0/16
Building configuration...
Current configuration : 115 bytes
!
interface GigabitEthernet1/0/16
no switchport
no ip address
no keepalive
ipv6 address FEC0:1016:1::1/64
end
switch# show ipv6 interface fastethernet1/0/16
FastEthernet1/0/16 is up, line protocol is up
IPv6 is enabled, link-local address is FE80::20B:46FF:FE2E:9047
Global unicast address(es):
Joined group address(es):
MTU is 1500 bytes
ICMP error messages limited to one every 100 milliseconds
ICMP redirects are enabled
ND DAD is enabled, number of DAD attempts: 1
ND reachable time is 30000 milliseconds
ND advertised reachable time is 0 milliseconds
ND advertised retransmit interval is 0 milliseconds
ND router advertisements are sent every 200 seconds
ND router advertisements live for 1800 seconds
Hosts use stateless autoconfig for addresses.

IPv6 Applications

The switch has IPv6 support for these applications:
•
•
•
•
•
For more information about managing these applications with Cisco IOS, see the "Managing Cisco IOS
Applications over IPv6" section in the Cisco IOS IPv6 Configuration Library at this URL:
OL-8915-03
FEC0:1016:1:0:20B:46FF:FE2E:9047, subnet is FEC0:1016:1::/64 [PRE]
valid lifetime 2591834 preferred lifetime 604634
FF02::1
FF02::2
FF02::1:FF2E:9047
Ping, traceroute, Telnet, TFTP, and FTP
Secure Shell (SSH) over an IPv6 transport
HTTP server access over IPv6 transport
DNS resolver for AAAA over IPv4 transport
Cisco Discovery Protocol (CDP) support for IPv6 addresses
Cisco Catalyst Blade Switch 3020 for HP Software Configuration Guide
Understanding IPv6
35-9