Cisco WS-C3020 Software Configuration Manual page 50

Default Settings After Initial Switch Configuration
IEEE 802.1Q tunneling and Layer 2 protocol tunneling are disabled. For more information, see
•
Chapter 15, "Configuring IEEE 802.1Q and Layer 2 Protocol Tunneling."
STP, PVST+ is enabled on VLAN 1. For more information, see
•
MSTP is disabled. For more information, see
•
Optional spanning-tree features are disabled. For more information, see
•
Optional Spanning-Tree Features."
Flex Links are not configured. For more information, see
•
the MAC Address-Table Move Update Feature."
DHCP snooping is disabled. The DHCP snooping information option is enabled. For more
•
information, see
IP source guard is disabled. For more information, see
•
and IP Source Guard."
Dynamic ARP inspection is disabled on all VLANs. For more information, see
•
"Configuring Dynamic ARP Inspection."
IGMP snooping is enabled. No IGMP filters are applied. For more information, see
•
"Configuring IGMP Snooping and MVR."
IGMP throttling setting is deny. For more information, see
•
Snooping and MVR."
The IGMP snooping querier feature is disabled. For more information, see
•
IGMP Snooping and MVR."
MVR is disabled. For more information, see
•
Port-based traffic
•
–
–
–
–
CDP is enabled. For more information, see
•
UDLD is disabled. For more information, see
•
SPAN and RSPAN are disabled. For more information, see
•
RSPAN."
RMON is disabled. For more information, see
•
Syslog messages are enabled and appear on the console. For more information, see
•
"Configuring System Message Logging."
SNMP is enabled (Version 1). For more information, see
•
No ACLs are configured. For more information, see
•
with ACLs."
Cisco Catalyst Blade Switch 3020 for HP Software Configuration Guide
1-12
Chapter 20, "Configuring DHCP Features and IP Source Guard."
Broadcast, multicast, and unicast storm control is disabled. For more information, see
Chapter 23, "Configuring Port-Based Traffic Control."
No protected ports are defined. For more information, see
Traffic Control."
Unicast and multicast traffic flooding is not blocked. For more information, see
"Configuring Port-Based Traffic Control."
No secure ports are configured. For more information, see
Traffic Control."
Chapter 16, "Configuring STP."
Chapter 17, "Configuring MSTP."
Chapter 19, "Configuring Flex Links and
Chapter 20, "Configuring DHCP Features
Chapter 22, "Configuring IGMP
Chapter 22, "Configuring IGMP Snooping and MVR."
Chapter 23, "Configuring Port-Based
Chapter 23, "Configuring Port-Based
Chapter 24, "Configuring CDP."
Chapter 26, "Configuring UDLD."
Chapter 27, "Configuring SPAN and
Chapter 28, "Configuring RMON."
Chapter 30, "Configuring SNMP."
Chapter 31, "Configuring Network Security
Chapter 1 Overview
Chapter 18, "Configuring
Chapter 21,
Chapter 22,
Chapter 22, "Configuring
Chapter 23,
Chapter 29,
OL-8915-03