Displaying Vlans; Configuring Vlan Trunks; Trunking Overview - Cisco WS-C3020 Software Configuration Manual

Displaying VLANs

Displaying VLANs
Use the show vlan privileged EXEC command to display a list of all VLANs on the switch, including
extended-range VLANs. The display includes VLAN status, ports, and configuration information. To
view normal-range VLANs in the VLAN database (1 to 1005), use the show VLAN database
configuration command (accessed by entering the vlan database privileged EXEC command).
Table 11-3
Table 11-3
Command
show
show current [vlan-id]
show interfaces [vlan
vlan-id]
show vlan [id vlan-id]
For more details about the show command options and explanations of output fields, see the command
reference for this release.

Configuring VLAN Trunks

These sections contain this conceptual information:
•
•
•
•
•

Trunking Overview

A trunk is a point-to-point link between one or more Ethernet switch interfaces and another networking device
such as a router or a switch. Ethernet trunks carry the traffic of multiple VLANs over a single link, and you
can extend the VLANs across an entire network.
Two trunking encapsulations are available on all Ethernet interfaces:
•
•
Figure 11-2
Cisco Catalyst Blade Switch 3020 for HP Software Configuration Guide
11-16
lists the commands for monitoring VLANs.
VLAN Monitoring Commands
Command Mode
VLAN database
configuration
VLAN database
configuration
Privileged EXEC
Privileged EXEC
Trunking Overview, page 11-16
Encapsulation Types, page 11-18
Default Layer 2 Ethernet Interface VLAN Configuration, page 11-19
Configuring an Ethernet Interface as a Trunk Port, page 11-19
Configuring Trunk Ports for Load Sharing, page 11-24
Inter-Switch Link (ISL)-Cisco-proprietary trunking encapsulation.
IEEE 802.1Q- industry-standard trunking encapsulation.
shows a network of blade switches that are connected by ISL trunks.
Chapter 11
Purpose
Display status of VLANs in the VLAN database.
Display status of all or the specified VLAN in the
VLAN database.
Display characteristics for all interfaces or for
the specified VLAN configured on the switch.
Display parameters for all VLANs or the
specified VLAN on the switch.
Configuring VLANs
OL-8915-03