Configuring Rmon - Cisco WS-C3020 Software Configuration Manual

Configuring RMON

Figure 28-1
Blade
switch
The switch supports these RMON groups (defined in RFC 1757):
•
•
•
•
Because switches supported by this software release use hardware counters for RMON data processing,
the monitoring is more efficient, and little processing power is required.
Configuring RMON
These sections contain this configuration information:
•
•
•
•
Cisco Catalyst Blade Switch 3020 for HP Software Configuration Guide
28-2
Remote Monitoring Example
Network management station with
generic RMON console application
RMON history
and statistic
collection enabled.
RMON alarms and
events configured.
SNMP configured.
Blade Servers
Statistics (RMON group 1)—Collects Ethernet statistics (including Fast Ethernet and Gigabit
Ethernet statistics, depending on the switch type and supported interfaces) on an interface.
History (RMON group 2)—Collects a history group of statistics on Ethernet ports (including Fast
Ethernet and Gigabit Ethernet statistics, depending on the switch type and supported interfaces) for
a specified polling interval.
Alarm (RMON group 3)—Monitors a specific management information base (MIB) object for a
specified interval, triggers an alarm at a specified value (rising threshold), and resets the alarm at
another value (falling threshold). Alarms can be used with events; the alarm triggers an event, which
can generate a log entry or an SNMP trap.
Event (RMON group 9)—Specifies the action to take when an event is triggered by an alarm. The
action can be to generate a log entry or an SNMP trap.
Default RMON Configuration, page 28-3
Configuring RMON Alarms and Events, page 28-3
Collecting Group History Statistics on an Interface, page 28-5
Collecting Group Ethernet Statistics on an Interface, page 28-5
Blade
switch
Blade Servers
(required)
Chapter 28 Configuring RMON
(optional)
(optional)
OL-8915-03