Changing The Pruning-Eligible List; Configuring The Native Vlan For Untagged Traffic - Cisco 2950G 24 - Catalyst Switch Software Configuration Manual

Configuring VLAN Trunks
This example shows how to remove VLAN 2 from the allowed VLAN list:
Switch(config)# interface fastethernet0/1
Switch(config-if)# switchport trunk allowed vlan remove 2
Switch(config-if)# end
Switch#

Changing the Pruning-Eligible List

The pruning-eligible list applies only to trunk ports. Each trunk port has its own eligibility list. VTP
pruning must be enabled for this procedure to take effect. The
page 15-14
Beginning in privileged EXEC mode, follow these steps to remove VLANs from the pruning-eligible
list on a trunk port:
Command
Step 1
configure terminal
Step 2 interface interface-id
Step 3 switchport trunk pruning vlan {add |
except | none | remove} vlan-list
[,vlan[,vlan[,,,]]
Step 4 end
Step 5
show interfaces interface-id switchport Verify your entries in the Pruning VLANs Enabled field of the display.
Step 6
copy running-config startup-config
To return to the default pruning-eligible list of all VLANs, use the no switchport trunk pruning vlan
interface configuration command.

Configuring the Native VLAN for Untagged Traffic

A trunk port configured with 802.1Q tagging can receive both tagged and untagged traffic. By default,
the switch forwards untagged traffic in the native VLAN configured for the port. The native VLAN is
VLAN 1 by default.
Note The native VLAN can be assigned any VLAN ID; it is not dependent on the management VLAN.
For information about 802.1Q configuration issues, see the
section on page
Catalyst 2950 Desktop Switch Software Configuration Guide
14-20
describes how to enable VTP pruning.
Purpose
Enter global configuration mode.
Enter interface configuration mode, and select the trunk port for which
VLANs should be pruned.
Configure the list of VLANs allowed to be pruned from the trunk. (See
the "VTP Pruning" section on page
For explanations about using the add, except, none, and remove
keywords, refer to the command reference for this release.
Separate nonconsecutive VLAN IDs with a comma and no spaces; use a
hyphen to designate a range of IDs. Valid IDs are from 2 to 1001.
Extended-range VLANs (VLAN IDs 1006 to 4094) cannot be pruned.
VLANs that are pruning-ineligible receive flooded traffic.
The default list of VLANs allowed to be pruned contains VLANs 2 to
1001.
Return to privileged EXEC mode.
(Optional) Save your entries in the configuration file.
14-16.
Chapter 14
"Enabling VTP Pruning" section on
15-4).
"802.1Q Configuration Considerations"
Configuring VLANs
78-14982-01