C H A P T E R 9 Configuring Interface Characteristics; Port-Based Vlans; Switch Ports; Understanding Interface Types - Cisco WS-C3020 Software Configuration Manual

Understanding Interface Types

Port-Based VLANs

A VLAN is a switched network that is logically segmented by function, team, or application, without
regard to the physical location of the users. For more information about VLANs, see
"Configuring VLANs."
VLAN as the receiving port. Network devices in different VLANs cannot communicate with one another
without a Layer 3 device to route traffic between the VLANs.
VLAN partitions provide hard firewalls for traffic in the VLAN, and each VLAN has its own MAC
address table. A VLAN comes into existence when a local port is configured to be associated with the
VLAN, when the VLAN Trunking Protocol (VTP) learns of its existence from a neighbor on a trunk, or
when a user creates a VLAN.
To configure normal-range VLANs (VLAN IDs 1 to 1005), use the vlan vlan-id global configuration
command to enter config-vlan mode or the vlan database privileged EXEC command to enter VLAN
database configuration mode. The VLAN configurations for VLAN IDs 1 to 1005 are saved in the VLAN
database. To configure extended-range VLANs (VLAN IDs 1006 to 4094), you must use config-vlan
mode with VTP mode set to transparent. Extended-range VLANs are not added to the VLAN database.
When VTP mode is transparent, the VTP and VLAN configuration is saved in the switch running
configuration, and you can save it in the switch startup configuration file by entering the copy
running-config startup-config privileged EXEC command.
Add ports to a VLAN by using the switchport interface configuration commands:
•
•
•
•

Switch Ports

Switch ports are Layer 2-only interfaces associated with a physical port. Switch ports belong to one or
more VLANs. A switch port can be an access port, a trunk port, or a tunnel port. You can configure a port
as an access port or trunk port or let the Dynamic Trunking Protocol (DTP) operate on a per-port basis
to set the switchport mode by negotiating with the port on the other end of the link. You must manually
configure tunnel ports as part of an asymmetric link connected to an IEEE 802.1Q trunk port. Switch
ports are used for managing the physical interface and associated Layer 2 protocols and do not handle
routing.
Configure switch ports by using the switchport interface configuration commands. Use the switchport
command with no keywords to put an interface that is in Layer 3 mode into Layer 2 mode.
When you put an interface that is in Layer 3 mode into Layer 2 mode, the previous configuration
Note
information related to the affected interface might be lost, and the interface is returned to its default
configuration.
For detailed information about configuring access port and trunk port characteristics, see
"Configuring VLANs."
802.1Q and Layer 2 Protocol Tunneling."
Cisco Catalyst Blade Switch 3020 for HP Software Configuration Guide
9-2
Packets received on a port are forwarded only to ports that belong to the same
Identify the interface.
For a trunk port, set trunk characteristics, and if desired, define the VLANs to which it can belong.
For an access port, set and define the VLAN to which it belongs.
For a tunnel port, set and define the VLAN ID for the customer-specific VLAN tag. See
"Configuring IEEE 802.1Q and Layer 2 Protocol Tunneling."
For more information about tunnel ports, see
Chapter 9 Configuring Interface Characteristics
Chapter 11,
Chapter 15, "Configuring IEEE
Chapter 15,
Chapter 11,
OL-8915-03