Configuring Etherchannels - Cisco WS-C3020 Software Configuration Manual

Configuring EtherChannels

Figure 33-3
Blade
Server 1
Client
Configuring EtherChannels
These sections contain this configuration information:
•
•
•
•
•
•
•
Make sure that the ports are correctly configured. For more information, see the
Note
Configuration Guidelines" section on page
After you configure an EtherChannel, configuration changes applied to the port-channel interface apply
Note
to all the physical ports assigned to the port-channel interface, and configuration changes applied to the
physical port affect only the port where you apply the configuration.
Cisco Catalyst Blade Switch 3020 for HP Software Configuration Guide
33-8
Load Distribution and Forwarding Methods
Blade
Server 16
Blade Switch with
source-based
forwarding enabled
EtherChannel
Cisco router
with destination-based
forwarding enabled
Client
Default EtherChannel Configuration, page 33-9
EtherChannel Configuration Guidelines, page 33-9
Configuring Layer 2 EtherChannels, page 33-10
Configuring Layer 3 EtherChannels, page 33-12
Configuring EtherChannel Load Balancing, page 33-15
Configuring the PAgP Learn Method and Priority, page 33-16
Configuring LACP Hot-Standby Ports, page 33-17
Chapter 33 Configuring EtherChannels and Layer 2 Trunk Failover
(required)
(required)
(optional)
(optional)
(optional)
33-9.
"EtherChannel
OL-8915-03